LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Engine Controls - Removal & Installation) >> Sensors >> Manifold Absolute Pressure Sensor >> Removal (2.2L)

Removal (2.2L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Numbers in parenthesis correspond to numbered components in referenced illustrations.
  1. Manifold Absolute Pressure (MAP) sensor is located on intake manifold, below throttle body. See Figure . Remove the air cleaner outlet resonator, air cleaner intake duct and vent hose.
  2. Disconnect the cruise control cable (2) from the throttle body (3) and the accelerator bracket (1). See Figure .
  3. Disconnect the cruise control cable (2) from the throttle body (3) and the accelerator bracket (1). See Figure .
  4. Remove the 2 accelerator bracket nuts (3). See Figure .
  5. Remove the accelerator bracket (2) from the throttle body (1). See Figure .
  6. Disconnect the MAP sensor harness connector.
  7. Remove the MAP sensor (2) from the intake manifold. See Figure .
  8. Inspect the MAP sensor and seal for damage. If the MAP sensor seal is damaged, the MAP sensor must be replaced.
scientia non olet · About LEMON Manuals