LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Engine Controls - Removal & Installation) >> Motors & Solenoids >> EVAP Canister Purge Solenoid >> Installation

EVAP Canister Purge Solenoid: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister purge valve on to the purge bracket.
  2. Install the EVAP canister purge valve and bracket. Tighten the purge bracket nut to specification. See TORQUE SPECIFICATIONS  .
  3. Connect the purge pipe to the EVAP canister purge valve.
  4. Connect the vacuum pipe to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve harness connector.


  1. Position the EVAP canister purge valve on the intake manifold.
  2. Install the EVAP canister purge valve retaining bolt. See Figure . Tighten the purge valve retaining bolt to specification. See TORQUE SPECIFICATIONS  .
  3. Connect the purge valve harness connector.
  4. Connect the canister purge valve pipe and the vacuum supply hose. See Figure .
scientia non olet · About LEMON Manuals