Removal (Plastic Collar)
WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE .
- Blow dirt out of the fitting using compressed air.
- Squeeze the plastic tabs of the male end connector. See Fig 1 .
- Pull the connection apart.
- Using a clean shop towel, wipe off the male pipe end. Check both ends of the fitting for dirt and burrs.
- If necessary, remove rust or burrs from the fuel pipes using an emery cloth. Use a radial motion with the fuel pipe end to prevent damage to the "O" ring sealing surface. Clean or replace the components and assemblies as required.
WARNING:
Wear safety glasses when using compressed air. Flying dirt particles may cause eye injury.