LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Engine Controls - Removal & Installation) >> Fuel Systems >> Chassis Fuel Hose/Pipes >> Installation

Chassis Fuel Hose/Pipes: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel pipes. See Figure .
  2. Position the fuel pipes in the body clips. See Figure .
  3. Install the fuel pipe mounting bolts into the body clips. Tighten the bolts to specification. See TORQUE SPECIFICATIONS  .
  4. Install the exhaust heat shield. Tighten the exhaust shield nuts and bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Remove the caps on the fuel pipes.
  6. Connect the quick-connect fittings at the fuel sender pipes.
  7. Lower the vehicle.
  8. Connect the quick-connect fittings at engine compartment fuel feed and return pipes.
  9. Connect the negative battery cable. Tighten to specification. See TORQUE SPECIFICATIONS  .
  10. Inspect for fuel leaks using the following procedure:
    • Turn ignition switch to RUN position, with the engine OFF for 2 seconds.
    • Turn ignition switch to OFF position for 10 seconds.
    • Turn ignition switch to RUN position, with the engine OFF.
    • Check for fuel leaks.
scientia non olet · About LEMON Manuals