LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Engine Controls - Removal & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister >> Removal

EVAP Canister: Removal

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. The EVAP canister is located underneath rear of vehicle. See Figure . Raise and support vehicle.
  2. Disconnect hoses from EVAP canister. See Fig 1 .
  3. Remove EVAP canister attaching bolt. See Fig 2 .
  4. Remove EVAP canister and the retainer. See Fig 3 .
  5. Remove the EVAP canister retainer from the canister. See Fig 4 .
Fig 1: Disconnecting Hoses From Charcoal Canister
G00129201Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Canister Attaching Bolt
G00217347Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing/Installing EVAP Canister & Retainer
G00217348Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing/Installing Retainer From EVAP Canister
G00217349Courtesy of GENERAL MOTORS CORP.