LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Engine Controls - Removal & Installation) >> Sensors & Switches >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the CKP sensor "O" ring and lubricate with a mineral based grease.
  2. Carefully insert the CKP sensor into the block. See Figure.
  3. Install the CKP sensor bolt. Tighten the CKP sensor bolt to specification. See TORQUE SPECIFICATIONS .
  4. Reconnect the CKP sensor harness connector.
  5. Reinstall the starter.
  6. Reinstall the front air deflector, if applicable.
  7. Lower the vehicle.
  8. Connect the negative battery cable. Tighten to specification. See TORQUE SPECIFICATIONS .
  9. Perform the CKP system Variation Learn Procedure. See CKP SYSTEM VARIATION LEARN PROCEDURE .
scientia non olet · About LEMON Manuals