LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Engine Controls - Removal & Installation) >> Fuel Systems (Gasoline) >> Fuel Tank >> Installation

Fuel Tank: Installation

WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the aid of an assistant, raise the fuel tank to the vehicle. See Figure.
  2. Install the fuel tank retaining straps. Tighten the strap bolts to specification. See TORQUE SPECIFICATIONS .
  3. Connect the EVAP vapor pipe to the EVAP canister.
  4. Connect the wiring harness into the multi-way rear body connector.
  5. Connect the fuel filler hose to the fuel tank. Tighten the fuel filler hose clamp to specification. See TORQUE SPECIFICATIONS .
  6. Install the rubber exhaust hangers.
  7. Install the exhaust heat shield. Tighten the exhaust shield nuts/bolt to specification. See TORQUE SPECIFICATIONS .
  8. Connect the fuel return pipe and fuel filter quick-connect fittings. See FUEL LINE QUICK CONNECT FITTINGS .
  9. Lower the vehicle.
  10. Refill the fuel tank.
  11. Install the fuel filler cap.
  12. Connect the negative battery cable. Tighten to specification. See TORQUE SPECIFICATIONS .
  13. Check for leaks by using the following procedure:
    • Turn ignition switch to RUN position for 2 seconds.
    • Turn ignition switch to OFF position for 10 seconds.
    • Turn ignition switch to RUN position.
    • Check for fuel leaks.
scientia non olet · About LEMON Manuals