LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Engine Control System - Removal & Installation) >> Sensors & Switches >> Power Steering Pressure Switch >> Removal

Power Steering Pressure Switch: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
  2. Remove right front tire and wheel assembly.
  3. Remove right front engine splash shield.
  4. Disconnect Power Steering Pressure (PSP) switch harness connector (3). See Fig 1 .
  5. Remove PSP switch from the pump.
Fig 1: Removing/Installing Power Steering Pressure Switch
G00196049Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals