Quick Connect Fitting(S) Service (Metal Collar): Removal
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE .
- Grasp both sides of the fitting. Twist the female connector 1/4 turn in each direction to loosen any dirt within the fitting.
- Blow any dirt out of the fitting using compressed air.
- Insert the Fuel Line Disconnect Tool (J 43178), or equivalent, into the female connector. Push the tool inward to release the locking tabs.
- Pull the connection apart. If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end to prevent damage to the "O" ring sealing surface. Use a clean shop towel to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and burrs. Clean or replace components if necessary.
WARNING:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.