LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (Engine Controls - System & Component Testing - 4.8L, 5.3L & 6.0L - Flex Fuel & Gasoline) >> Fuel Systems >> Fuel Composition Sensor >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2003 Hummer H2, 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, and 2003 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
  1. Test fuel composition using the Fuel Composition Tester (J-44175) and instruction manual. Record the frequency from the special tool test. Compare the special tool test frequency and the Fuel Comp. Sensor Frequency parameter on scan tool. Is the difference between the 2 frequencies less than 12 Hz? If yes, go to next step. If yes, go to step  3 .
  2. Clean fuel system. Refer to FUEL SYSTEM CLEANING  . Replace fuel filter. After repairs, go to step  4 .
  3. Replace the fuel composition sensor, located near fuel filter. After replacing sensor, go to next step.
  4. Clear any DTCs with scan tool. Start engine. Operate vehicle in order to verify the repair. Did you correct the condition? If yes, system is okay. If no, go to next step.
  5. Observe the DTC Info with scan tool. Are there any DTCs that have not been diagnosed? If yes, go to See DIAGNOSTIC TROUBLE CODE DEFINITIONS in SELF-DIAGNOSTICS - 4.8L, 5.3L & 6.0L "C", "K" & "N" SERIES - FLEX FUEL & GASOLINE article or DIAGNOSTIC TROUBLE CODE DEFINITIONS in SELF-DIAGNOSTICS - 4.8L, 5.3L & 6.0L EXPRESS & SAVANA - GASOLINE article. If no, system is okay.
scientia non olet · About LEMON Manuals