LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Removal & Installation - A/T (VT25-E)) >> Removal & Installation >> Side Mount >> Removal

Side Mount: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue and 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the front transaxle mount through bolt. See Figure .
  3. Remove the rear transaxle mount through bolt. See Figure .
  4. Lower the vehicle.
  5. Remove the battery box. See appropriate SERVICING article as follows:
    • For 2002 models, see BATTERY COOLING BOX under REMOVAL & INSTALLATION in SERVICING - VUE (VT25-E) article.
    • For 2003 models, see BATTERY COOLING BOX under REMOVAL & INSTALLATION in SERVICING - VUE (VT25-E) article.
  6. Support the powertrain assembly using a floor jack with a 2x6 block of wood.
  7. Remove the right engine mount-to-mount bracket bolts. See Figure .
  8. Remove the left transaxle mount-to-transaxle bolts. See Figure .
  9. Lower the engine in order to gain clearance for mount removal.
  10. Remove the left transaxle mount-to-side rail bolts. See Fig 1 .
  11. Remove the transaxle mount from the side rail.
Fig 1: Removing Left Transaxle Mount-To-Side Rail Bolts
G00210862Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals