LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Removal & Installation - A/T (VT25-E)) >> Removal & Installation >> Rear Mount Bracket >> Installation

Rear Mount Bracket: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue and 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. On FWD models, install the transaxle mount bracket to the transaxle. See Figure . Tighten bracket-to-transaxle bolts to specification. See TORQUE SPECIFICATIONS  .
  2. On AWD models, install the transaxle mount bracket to the power takeoff. See Figure . Tighten bracket-to-power takeoff bolts to specification. See TORQUE SPECIFICATIONS  .
  3. On all models, install the rear transaxle mount. See Figure . See REAR MOUNT  .
  4. Lower the steering gear in to the steering gear mounts. See Figure .
  5. Hand start both steering gear to frame bolts.
  6. Tighten the steering gear-to-frame bolts. Tighten bolts to specification. See TORQUE SPECIFICATIONS  .
  7. Install the intermediate steering shaft to the steering gear.
  8. Install a NEW intermediate steering shaft pinch bolt. See Figure . Tighten bolt to specification. See TORQUE SPECIFICATIONS  .
  9. Connect the stabilizer link to the stabilizer shaft. See Figure . Tighten nut to specification. See TORQUE SPECIFICATIONS  .
  10. Install the left outer tie rod to the steering knuckle. See Figure . See OUTER TIE ROD END  .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals