LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Removal (1500 Series With 4-Wheel Steering)

Removal (1500 Series With 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the tire and wheel assembly.
  4. Relieve the tension from the park brake cable by pulling down on the intermediate cable then release the cable from the equalizer bar. See Figure.
  5. Remove the rear park brake bracket bolt. See Figure.
  6. Remove the park brake cable from the park brake actuator lever. See Figure.
  7. Remove the wheel bearing. See REAR WHEEL HUB ASSEMBLY under REMOVAL & INSTALLATION in the 9.75" RING GEAR - QUADRASTEER article in DRIVELINE/AXLES.
  8. Remove the park brake shoe.
  9. Remove the park brake actuator lever housing from the backing plate.
  10. Remove the backing plate.
scientia non olet · About LEMON Manuals