LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation (2500 & 3500 Series)

Installation (2500 & 3500 Series)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the axle housing flange.
  2. Install the backing plate nuts. See Figure. Tighten the backing plate bolts to specification. See TORQUE SPECIFICATIONS .
  3. Install the park brake shoe. See PARK BRAKE SHOES .
  4. Install the axle shaft. See AXLE SHAFTS under REMOVAL & INSTALLATION in the appropriate RING GEARS article in DRIVELINE/AXLES.
  5. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
  6. Install the rotor. See BRAKE ROTOR .
  7. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  8. Install the rear park brake cable to the park brake actuator lever.
  9. Tighten the nut to the intermediate cable at the equalizer. See Figure. Tighten the nut to specification. See TORQUE SPECIFICATIONS .
  10. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  11. Remove the safety stands.
  12. Lower vehicle.
  13. Adjust park brake cable. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
scientia non olet · About LEMON Manuals