LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Park Brake Shoes >> Removal (With 4-Wheel Steering)

Removal (With 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the tire and wheel assembly.
  4. Relieve the tension from the park brake cable by pulling down on the intermediate cable then release the cable from the equalizer bar. See Figure.
  5. Remove the rear park brake bracket bolt. See Fig 1.
  6. Remove the park brake cable from the park brake actuator lever. See Fig 2.
  7. Remove the wheel bearing. See REAR WHEEL HUB ASSEMBLY under REMOVAL & INSTALLATION in the 9.75" RING GEAR - QUADRASTEER article in DRIVELINE/AXLES.
  8. Remove the park brake assembly and backing plate from the steering knuckle.
  9. Remove the park brake shoe retaining clip bolt and retaining clip.
  10. Remove the park brake shoe from the actuator.
Fig 1: Removing Park Brake Bracket Bolt
G00317480Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Park Brake Cable
G00317481Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals