LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal (Right Rear - Without 4-Wheel Steering)

Removal (Right Rear - Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Relieve the tension on the cable by loosening the nut at the equalizer. See Figure.
  4. Disconnect the cable from the equalizer.
  5. Remove the bolt from the rear axle clip. See Fig 1.
  6. Remove the cable from the differential clip.
  7. Remove the cable from the mounting bracket by depressing the locking tabs. See Figure.
  8. Remove the cable from the left and right side cable guides (1500 series utilities). See Fig 2.
  9. Remove the cable from the track bar clips.
  10. On all models except 1500 series utilities, remove the cable from the lever. See Figure.
  11. Remove the cable from the backing plate by depressing the locking tabs.
  12. Remove the cable from the retaining bracket.
  13. Remove the cable.
  14. On 1500 series utilities, remove the cable from the lever. See Figure.
  15. Remove the cable from the backing plate by depressing the locking tabs.
  16. Remove the cable from the retaining bracket.
  17. Remove the cable.
Fig 1: Removing Bolt From Rear Axle Clip
G00317492Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Cable From Guides
G00317493Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals