LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal (Right Rear - With 4-Wheel Steering)

Removal (Right Rear - With 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the park brake cable from the equalizer by pulling down on the intermediate cable and release the cable from the equalizer bar. See Figure.
  4. Remove the cable from the mounting bracket by depressing the locking tabs. See Figure.
  5. Remove the park brake cable from the differential clip. Remove the bolt retaining the park brake cable from the rear axle clip. See Figure.
  6. Remove the rear brake cable mounting bracket bolt. See Fig 1.
  7. Remove the brake cable from the lever. See Figure.
  8. Remove the cable from the rear brake cable mounting bracket by depressing the locking tabs on the brake cable. See Figure.
  9. Remove the brake cable from the guides and the body mounts. See Figure.
Fig 1: Removing Cable Mounting Bracket Bolt
G00317495Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals