LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Park Brake Cable Equalizer >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the nut from the threaded end of the intermediate cable. See Figure.
  4. Disconnect the equalizer from the rear park brake cables.
  5. To install, connect the equalizer to the rear park brake cables.
  6. Install the nut to the threaded end of the intermediate cable. See Figure. Tighten the nut to specification. See TORQUE SPECIFICATIONS .
  7. Remove the safety stands.
  8. Lower the vehicle.
  9. Adjust the park brake system. PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
scientia non olet · About LEMON Manuals