LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Park Brake Actuator >> Removal (1500 Series)

Removal (1500 Series)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the tire and wheel assembly.
  4. Relieve the tension from the park brake cables from the equalizer by pulling down on the intermediate cable and release the rear cables from the equalizer bar.
  5. Remove the rear park brake cable from the park brake actuator lever.
  6. On vehicles without 4-wheel steering, remove the park brake cable from the mounting bracket by depressing the locking tabs.
  7. On vehicles with 4-wheel steering, remove the rear park brake bracket bolt. See Figure.
  8. On all vehicles, remove the rotor. See BRAKE ROTOR .
  9. Remove the axle shaft. See AXLE SHAFTS under REMOVAL & INSTALLATION in the appropriate RING GEARS article in DRIVELINE/AXLES.
  10. Remove the park brake shoe. See PARK BRAKE SHOES .
  11. Remove the backing plate bolts. See Fig 1.
  12. Remove the park brake actuator lever housing from the backing plate.
Fig 1: Removing Backing Plate Bolts
G00317497Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals