LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Disc Brake Hardware >> Removal (Front)

Removal (Front)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPER .
  4. Remove the disc brake pads from the disc brake caliper mounting bracket. See Figure.
  5. Remove the disc brake pad retainers from the disc brake caliper mounting bracket.
  6. Inspect the disc brake hardware. See DISC BRAKE MOUNTING & HARDWARE INSPECTION  under ADJUSTMENTS & INSPECTION.
  7. Remove the caliper pin boots from the disc brake caliper mounting bracket. See Figure.
scientia non olet · About LEMON Manuals