LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Brake Caliper Bracket >> Removal (Rear - 4-Wheel Steering)

Removal (Rear - 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the nut and the bolt from the quarter shaft shield. See Fig 1.
  4. Remove the shield.
  5. Remove the 2 brake caliper mounting bolts. See Fig 2.
  6. Remove the brake caliper and support with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the brake caliper.
  7. Remove the 2 brake caliper mounting bracket bolts. See Fig 3.
  8. Remove the disc brake pads from the brake caliper mounting bracket. See Figure.
  9. Remove the anti-rattle clips from the brake caliper mounting bracket.
Fig 1: Removing Quarter Shaft Shield Nut & Bolt
G00310160Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing 2 Caliper Mounting Bolts
G00310161Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing 2 Caliper Mounting Bracket Bolts
G00310162Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals