LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Brake Caliper Bracket >> Removal (Front)

Removal (Front)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPER .
  2. Remove the brake pads. See Figure.
  3. Remove the anti-rattle clips from the brake caliper bracket.
  4. Remove the brake caliper bracket mounting bolts. See Fig 1.
  5. Remove the brake caliper bracket.
  6. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
  7. Clean the mounting surface and threads of the brake caliper bracket.
Fig 1: Removing Caliper Bracket Mounting Bolts
G00310159Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals