LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Overhaul >> Brake Caliper >> Reassembly (Rear - 2500 & 3500 Series)

Reassembly (Rear - 2500 & 3500 Series)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper bleed screw. See Figure. Tighten the brake caliper bleed screw to specification. See TORQUE SPECIFICATIONS .
  2. Install the brake caliper bleed screw cap.
  3. Lubricate the NEW piston seal and the brake caliper bore seal groove with brake fluid.
  4. Install NEW the seal into the brake caliper bore seal groove.
  5. Ensure that the seal is not twisted.
  6. Lubricate the brake caliper bore and the piston with brake fluid.
  7. Install the boot and the piston.
    1. Install the boot over the end of the piston so that the fold will face toward the brake caliper housing piston bore opening.
    2. Seat the boot into the brake caliper bore groove. Slide the piston into the brake caliper bore.
    3. Push down the piston to the bottom of the brake caliper bore.
    4. Ensure that the boot properly seats into the piston groove and into the groove in the brake caliper bore.
    5. Repeat steps 5 and 6 for the remaining piston.
  8. Install the brake caliper to the vehicle. See BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals