Section 224 (Engine Controls - Trouble Shooting - No Codes): Introduction

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Before diagnosing symptoms or intermittent faults, follow proper workflow. See DIAGNOSTIC STARTING POINT - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 2.2L VUE article or DIAGNOSTIC STARTING POINT - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 3.0L VUE article. If no Diagnostic Trouble Codes (DTC) are present and a no start condition exists, proceed to NO-START DIAGNOSIS in BASIC DIAGNOSTIC PROCEDURES - 2.2L & 3.0L VUE article. If no DTCs are present and a driveability condition exists, diagnosis by symptom (i.e., ROUGH IDLE, ENGINE STALLS, etc.).

NOTE: Some driveability problems may have been corrected by manufacturer with a revised computer calibration chip or computer control unit. Check with manufacturer for latest chip or computer application.

Use intermittent test procedures to locate driveability problems that do not occur when the vehicle is being tested. These test procedures should also be used if a soft (intermittent) trouble code was present but no problem was found during self-diagnostic testing.

NOTE: For specific testing procedures, see SYSTEM & COMPONENT TESTING - 2.2L & 3.0L VUE article. For specifications, see ON-VEHICLE ADJUSTMENT - TRUCKS - EXCEPT TRACKER or SERVICE & ADJUSTMENT SPECIFICATIONS - 2.2L & 3.0L VUE article.