LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Installation (Front)

Installation (Front)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix and 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front cable into the vehicle. See Figure . Connect the cable to the park brake lever. Install the cable button in the lever clevis.
  2. Install the cable button clip to the lever clevis.
  3. Raise and suitably support the vehicle.
  4. Tighten the nut on the equalizer in order to remove the slack in the cable.
  5. Lower the vehicle.
  6. Install the park brake cable through the park brake cable guides.
  7. Position the carpeting properly.
  8. Install the lower center pillar trim panel on the left side.
  9. Install the left side carpet retainers.
  10. Install the left side instrument panel insulator.
  11. Adjust the park brake. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
scientia non olet · About LEMON Manuals