LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Disc Brakes) >> Removal & Installation >> Front Brake Hose >> Removal

Front Brake Hose: Removal

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix and 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the front tire and wheel assembly.
  3. Clean all dirt and foreign material from the brake hoses and brake pipe fitting.
    NOTE: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
  4. Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end. See Fig 1 . DO NOT bend the brake pipe or the bracket.
  5. Remove the brake hose retaining clip from the hose mounting bracket.
  6. Remove the hose from the bracket.
  7. Remove the brake hose to caliper bolt from the brake caliper. See Fig 2 .
  8. Remove the brake hose from the brake caliper. Remove and discard the 2 copper brake hose gaskets.
  9. These gaskets may be stuck to the brake caliper and/or the brake hose end.
Fig 1: Identifying Front Brake hose (1 Of 2)
G00310763Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Front Brake hose (2 Of 2)
G00310764Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals