LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Engine Controls - Basic Diagnostic Procedures - 4.3L) >> Preliminary Inspection & Adjustments >> Mechanical Inspection >> Cylinder Compression Pressure

Cylinder Compression Pressure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Sonoma, 2003 GMC Safari, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Check engine mechanical condition with compression gauge, vacuum gauge, or engine analyzer. See engine analyzer manual for specific instructions. For compression specifications, see ENGINE COMPRESSION SPECIFICATIONS  table. Install and tighten spark plugs to 11 ft. lbs. (15 N.m).

ENGINE COMPRESSION SPECIFICATIONS

Application Specification - psi (kPa)
Normal Compression Pressure (1)
Minimum Compression Pressure (1)
Compression Variance (2)
(1) Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 100 psi (689.5 kPa).
(2) Information is not available from manufacturer.