LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Automatic Transmission Servicing - (AWD)) >> Lubrication >> Oil Cooler Flushing & Flow Check >> Back Flush

Back Flush

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect both hoses from the oil cooler pipes and then connect them to the opposite oil cooler pipe. This will allow the oil cooler and pipes to be back flushed.
  2. Repeat steps  3 and  4 of the INITIAL FLUSH procedure.
  3. Release the trigger (8) of the transaxle oil cooler and line flusher and allow water only to rinse the oil cooler and pipes for one minute.
  4. Turn the water supply valve (1) to the OFF position and turn off the water supply at the faucet.
  5. Attach the shop air supply to the flushing system feed air valve (2) on the and blow out the water from the oil cooler and pipes. Continue until no water comes out of the discharge hose (5).
scientia non olet · About LEMON Manuals