Installation Procedure
WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the underhood fuse block(s) battery cable and buss bar terminals to the fuse block(s) by sliding up into place until fully seated.
- Install the buss bar(s) to the fuse block(s) pressing into place until fully seated.
- Position the underhood fuse block terminal positive assurance retainers to the fuse block(s).
- Install the underhood fuse block(s) terminal positive assurance retainers pressing into place until fully seated.
- Install the fuses to the fuse block(s) that were removed to access the buss bar terminal release tabs.
- Install the buss bar jumper bar to the fuse block(s).
- Install the bolts to the buss bar jumper bar. Tighten the jumper bar bolts to 9 N.m (80 lb in).
- Install the plastic shields to the battery cable and buss bar terminals pressing into place until fully seated.
- Position the underhood fuse block(s) to the underhood fuse block base retaining locks.
- Install the underhood fuse block(s) into the underhood fuse block base retaining locks pressing in until fully seated.
- Install new tape to the wiring harness at the base of the underhood fuse block base.
- Position the underhood fuse block base to the shock tower.
- Install the nuts to the underhood fuse block base. Tighten the fuse block base nuts to 9 N.m (80 lb in).
- Install the positive battery cables to the underhood fuse block. Tighten the positive battery cables nuts to 15 N.m (11 lb ft).
- Connect the negative battery cable.