LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2021 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center Or Junction Block Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the body wiring harnesses to the junction block. Tighten the body wiring harness connector bolts to 7 N.m (62 lb in).
  2. Install the junction block tabs to the passenger knee bolster.
  3. Install the junction block bolt. Tighten the junction block bolt to 10 N.m (89 lb in).
  4. Close the IP compartment.
  5. Connect the body wiring harness to the junction block.
  6. Install the RH IP fuse block access opening cover.
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals