LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2021 (Wiring Systems (General Information)) >> Repair Instructions >> Instrument Panel Electrical Center Or Junction Block Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the body wiring harness to the junction block.
  2. Install the junction block tab to the slot in the cross vehicle beam.
  3. Install the junction block bolts. Tighten the junction block bolts to 10 N.m (89 lb in).
  4. Connect the body wiring harness to the junction block. Tighten the body wiring harness connector bolt to 7 N.m (62 lb in).
  5. Install the instrument panel (IP) cluster trim plate.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals