LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2021 (Wiring Systems (General Information)) >> Diagnostic Information & Procedures >> Repairing Connector Terminals

Repairing Connector Terminals

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 38125-B  Terminal Repair Kit

Use the following repair procedures in order to repair the following:

Some terminals do not require all of the steps shown. Skip the steps that do not apply for your immediate terminal repair. The J 38125-B  contains further information.

  1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss. For Weather Pack® terminals, remove the seal.
  2. Apply the correct seal per gage size of the wire. For Weather Pack® terminals, slide the seal back along the wire in order to enable insulation removal.
  3. Remove the insulation.
  4. For Weather Pack® terminals only, align the seal with the end of the cable insulation.
  5. Position the strip in the terminal. For Weather Pack® terminals, position the strip and seal in the terminal.
  6. Hand crimp the core wings.
  7. Hand crimp the insulation wings. For Weather Pack® terminals, hand crimp the insulation wings around the seal and the cable.
  8. Solder all of the hand crimp terminals.
scientia non olet · About LEMON Manuals