LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Automatic Transmission Servicing - (Fwd)) >> Removal & Installation >> Manual Selector >> Removal

Manual Selector: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Perform the following procedures to remove the center instrument trim panel:
    1. Using a taped flat bladed tool, gently pry and release the retaining clips which secure the I/P accessory center trim plate (1) to the instrument panel assembly. See Fig 1 .
    2. Disconnect the A/C switch electrical connector, the hazard warning switch electrical connector, the rear defogger switch electrical connector, and the passenger seat belt indicator electrical connector.
  3. Perform the following procedures to remove the instrument compartment:
    1. Open the instrument panel compartment door.
    2. Remove the screw (3). See Fig 2 .
    3. Compress each side of the I/P compartment, until the upper tabs (1) release.
    4. Remove the I/P compartment (2) by pulling out to disengage lower tabs (4).
  4. Perform the following procedures to remove the front floor console:
    1. Remove the center A/C control knob (3) and screw (1). See Fig 3 .
    2. Using a taped flat bladed tool, gently pry and release the retaining clips which secure the front floor console trim plate (2) to the front floor console assembly.
    3. Disconnect the 2 cigar lighter electrical connectors and the accessory power receptacle electrical connectors.
  5. Push in the retaining clip, then disconnect the cable from the shifter assembly. See Fig 4 .
  6. Using a screwdriver, disconnect the park lock cable from the bracket. See Fig 5 .
  7. Disconnect the shift select cable from the manual selector lever. See Fig 6 .
  8. Using a screwdriver, disconnect the shift select cable from the shift lever plate. See Fig 7 .
  9. Disconnect the electrical connectors, then the wire harness clip. See Fig 8 .
  10. Remove the 4 nuts, then the manual selector from the vehicle. See Fig 9 .
Fig 1: Removing Center Trim Plate
G00170219Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Instrument Panel Compartment
G00170220Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Front Floor Console Trim Plate
G00170221Courtesy of GENERAL MOTORS CORP.
Fig 4: Disconnecting Cable From Shifter Assembly
G00170214Courtesy of GENERAL MOTORS CORP.
Fig 5: Disconnecting Park Lock Cable
G00170215Courtesy of GENERAL MOTORS CORP.
Fig 6: Disconnecting Shift Select Cable
G00170216Courtesy of GENERAL MOTORS CORP.
Fig 7: Disconnecting Shift Select Cable
G00170204Courtesy of GENERAL MOTORS CORP.
Fig 8: Disconnecting Electrical Connectors & Wiring Harness Clip
G00170217Courtesy of GENERAL MOTORS CORP.
Fig 9: Remove Manual Selector
G00170218Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals