LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Automatic Transmission Servicing - (Fwd)) >> Removal & Installation >> Cooler Pipes & Hoses >> Installation

Cooler Pipes & Hoses: Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install or connect the fluid cooler inlet pipe, outlet pipe and bracket to the transaxle. Secure the pipe bracket to the transaxle with one bolt. Tighten the transaxle inlet and outlet fluid cooler pipe flare nuts to specification. Tighten the fluid cooler pipe bracket bolt to specification. See TORQUE SPECIFICATIONS  .
  2. Install the following to the transaxle and fluid cooler:
    1. The fluid cooler inlet hose to the fluid cooler inlet pipe. Secure with the one clamp.
    2. The fluid cooler inlet hose to the transaxle fluid cooler. Secure with the one clamp.
    3. The fluid cooler outlet hose to the fluid cooler outlet pipe. Secure with the one clamp.
    4. The fluid cooler outlet hose to the transaxle fluid cooler. Secure with the one clamp.
  3. Remove the drain pan from under the transaxle fluid cooler.
  4. Refill the transaxle with appropriate fluid, as necessary. See RECOMMENDED FLUIDS  under LUBRICATION.
scientia non olet · About LEMON Manuals