LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2016 (Engine Mechanical - 3.6L (6 Of 6)) >> Repair Instructions - Off Vehicle (4 Of 4) >> Intake Manifold Installation (LCS)

Intake Manifold Installation (LCS)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Manifold Gasket
    GM2137804Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW intake manifold gasket (1).
    2. Fig 2: Intake Manifold Assembly & Bolts
    GM2137802Courtesy of GENERAL MOTORS CORP.
  2. Install the intake manifold assembly (3).
  3. Install the intake manifold bolts (1, 2).
    4. Fig 3: Intake Manifold Bolt Tightening Sequence
    GM2091550Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Tighten the intake manifold bolts in the sequence shown.
  5. Tighten the intake manifold bolts in sequence to 23 N.m (17 lb ft).
  6. Tighten the intake manifold bolts a second pass in sequence to 23 N.m (17 lb ft).
    7. Fig 4: Fuel Pump Cover
    GM2137797Courtesy of GENERAL MOTORS CORP.
  7. Install the fuel pump cover (2).
  8. Install the fuel pump cover bolt (1) and tighten to 10 N.m (89 lb in).
    9. Fig 5: Evaporative (EVAP) Solenoid
    GM2137795Courtesy of GENERAL MOTORS CORP.
  9. Install the evaporative (EVAP) solenoid (1).
  10. Tighten the EVAP solenoid bolt to 10 N.m (89 lb in).
    11. Fig 6: Evaporative (EVAP) Solenoid
    GM2137794Courtesy of GENERAL MOTORS CORP.
  11. Connect the EVAP hose to the upper intake manifold and EVAP solenoid.
    12. Fig 7: Positive Crankcase Ventilation (PCV) Tube Assembly
    GM2137793Courtesy of GENERAL MOTORS CORP.
  12. Connect the positive crankcase ventilation (PCV) tube assembly (1) to the upper intake manifold and the right camshaft cover.
scientia non olet · About LEMON Manuals