LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2015 (Engine Mechanical - 3.6L (5 Of 6)) >> Repair Instructions - Off Vehicle (3 Of 4) >> Valve Rocker Arm Installation - Left Side

Valve Rocker Arm Installation - Left Side

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Valve Rocker Arm Lubrication Areas
    GM1400021Courtesy of GENERAL MOTORS CORP.
  1. Apply a liberal amount of lubricant GM P/N 12345501 (Canadian P/N 992704) or equivalent to the pivot pocket (1), roller (2) and valve slot (3) areas of the camshaft followers.
    2. Fig 2: View Of Valve Rocker Arm
    GM902907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
  2. Place the camshaft followers in position on the valve tip and stationary hydraulic lash adjuster (SHLA).
  3. The rounded head end of the follower goes on the SHLA while the flat end goes on the valve tip.
  4. Clean the camshaft journals and carriers with a clean, lint-free cloth.
scientia non olet · About LEMON Manuals