LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2015 (Engine Mechanical - 3.6L (5 Of 6)) >> Repair Instructions - Off Vehicle (3 Of 4) >> Intake Manifold Disassemble (LY7) >> Upper to Lower Intake Manifold Disassemble Procedure

Upper to Lower Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper-To-Lower Intake Manifold Bolts
    GM1866894Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the upper-to-lower intake manifold gasket and the intake manifold-to-cylinder head sealing gaskets.
  1. Remove the upper-to-lower intake manifold bolts.
    2. Fig 2: Fuel Injector Wiring Harness Bracket Bolts
    GM1866896Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel injector wiring harness bracket bolt from the upper intake manifold.
    3. Fig 3: Upper And Lower Intake Manifolds
    GM1866897Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper intake manifold from the lower intake manifold.
    4. Fig 4: Upper-To-Lower Intake Manifold Gaskets
    GM1866898Courtesy of GENERAL MOTORS CORP.
  4. Remove and discard the upper-to-lower intake manifold gaskets.
scientia non olet · About LEMON Manuals