LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2010 (Power Seat System) >> Diagnostic Information and Procedures >> Power Seat Inoperative >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Seat Adjuster Switch

  1. Ignition OFF, disconnect the harness connector at the driver seat adjuster switch.
  2. Test for infinite resistance between the B+ terminal E and each control terminal the with the switch in the open position.
    • If not the specified value, replace the seat adjuster switch.
  3. Test for less than 2 Ω between the B+ terminal E and each control terminal with the appropriate switch in the closed position.
    • If greater than the specified range, replace the seat adjuster switch.
  4. Test for less than 2 Ω between the ground terminal B and each control terminal with the switch in the open position.
    • If greater than the specified range, replace the seat adjuster switch.
scientia non olet · About LEMON Manuals