LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2000 (Automatic Transmission - 4T45-E - DTC P0973 To DTC P2797) >> DTC P2763 or P2764 (Non-Hybrid) >> Circuit/System Testing (Non-Hybrid)

Circuit/System Testing (Non-Hybrid)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Additional DTCs may set when disconnecting the automatic transmission inline 20-way connector.
  1. Ignition OFF, disconnect the automatic transmission (AT) inline 20-way connector at the transmission.
  2. Install the J 44152  on the engine side of the AT inline 20-way connector.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal E and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, test all components connected to the ignition circuit and replace as necessary.
  4. Connect a test lamp between the control circuit terminal T and the ignition circuit terminal E.
  5. Command the TCC Control Solenoid to 90 percent and then back to 0 percent with a scan tool. The test lamp should turn ON when commanded to 90 percent and then turn OFF when 0 percent is commanded.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the TCM.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the TCM.
  6. If all circuits test normal, test the automatic transmission internal wiring harness and the TCC PWM solenoid.
scientia non olet · About LEMON Manuals