Circuit/System Verification (Hybrid)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the Transmission Fluid Check .
- Ignition ON, engine off, gear selector in Park, Reverse, Neutral, or Drive, observe the scan tool ECM TFP switch A parameter should read Low. Engine running, observe the scan tool ECM TFP switch A parameter should read High.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.