LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2000 (Automatic Transmission - 4T45-E - DTC P0973 To DTC P2797) >> DTC P0976 or P0977 (Non-Hybrid) >> Circuit/System Testing (Non-Hybrid)

Circuit/System Testing (Non-Hybrid)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Additional DTCs may set when disconnecting the automatic transmission inline 20-way connector.
  1. Ignition OFF, disconnect the automatic transmission (AT) inline 20-way connector at the transmission.
  2. Install the J 44152  on the engine side of the AT inline 20-way connector.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal E and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, test all components connected to the ignition circuit and replace as necessary.
  4. Connect a test lamp between the control circuit terminal B and the ignition circuit terminal E.
  5. Command the 2-3 SS ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the TCM.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the TCM.
  6. If all circuits test normal, test the automatic transmission internal wiring harness and the 2-3 shift solenoid.
scientia non olet · About LEMON Manuals