Component Testing (Non-Hybrid)
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the automatic transmission (AT) inline 20-way connector at the transmission.
- Install the J 44152 on the transmission side of the AT inline 20-way connector.
- Test for 19-31 ohms of resistance between the control terminal A and the ignition terminal E of the transmission.
- If not within the specified range, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted or open replace the internal transmission harness, if the circuits test normal, replace the 2-3 shift solenoid.
- Test for infinite resistance between each terminal and the transmission housing/case.
- If not the specified value, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted replace the internal transmission harness, if the circuits test normal, replace the 2-3 shift solenoid.