LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1998 (Engine Controls And Fuel - 3.6L (LCS) - DTC P0638 To DTC P2229) >> DTC P0650 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function.
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
    • If the hood position does not display Open, refer to DTC P254F .
  3. If any other IPC indicators or gages are inoperative, refer to Instrument Cluster Gages Inoperative .
  4. Ignition OFF, disconnect the ECM harness connectors. Ignition ON, the MIL should not illuminate.
    • If the MIL is illuminated, test the MIL control circuit terminal X2-12 for a short to ground. If the circuit tests normal, replace the IPC.
  5. Ignition ON, connect a 3 A fused jumper wire between the MIL control circuit terminal X2-12 and ground. The MIL should illuminate.
    • If the MIL does not illuminate, test the MIL control circuit for a short to voltage, or an open/high resistance. If the circuit test normal, replace the IPC/bulb.
  6. If all circuits/connections test normal, replace the ECM.
scientia non olet · About LEMON Manuals