Circuit/System Verification
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- If there are any other DTCs set, diagnose those first.
- Using a scan tool compare the desired engine idle speed to the actual engine idle speed.
- Actual engine idle speed should be no greater than 150 RPM below desired.
- Actual engine idle speed should be no greater than 100 RPM above desired.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.