LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1997 (Engine Controls And Fuel - 2.4L - DTC P0324 To DTC P1400) >> DTC P0420 (Lat) >> Circuit/System Testing (LAT)

Circuit/System Testing (LAT)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Three-Way Catalytic Converter Damage Caution .
CAUTION: Refer to Heated Oxygen Sensor Resistance Learn Reset Caution .
NOTE: A new converter with less than 100 miles on it may set DTC P0420 due to out-gassing of the internal matting. Operating the vehicle at highway speeds for approximately 1 hour may correct the condition.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description.
  2. Ignition ON, verify the scan tool Hood Position parameter displays Open.
  3. Inspect for the following conditions, which may cause a catalytic converter to degrade:
    • An engine misfire
    • High engine oil or high coolant consumption
    • Retarded spark timing
    • A weak or poor spark
    • A lean fuel mixture
    • A rich fuel mixture
    • A damaged oxygen sensor or wiring harness
    • The catalyst test may abort if the vehicle falls outside the Conditions for Running the DTC.
    • A catalyst may be temporarily degraded if a fuel with high sulfur content has been used. Drive the vehicle at highway speeds for 10 minutes and retest the converter.
  4. Inspect the catalytic converter for the following conditions:
    • Dents
    • A severe discoloration caused by excessive temperatures
    • Road damage
    • An internal rattle caused by damaged catalyst substrate
    • Restrictions
    • If a condition is found, replace the catalytic converter.
  5. Inspect the exhaust system for the following conditions:
    • Leaks
    • Physical damage
    • Loose or missing hardware
    • Properly torqued HO2S
    • Restrictions
    • If a condition is found, repair the exhaust system.
  6. Inspect the post catalyst HO2S for the following conditions:
    • A grounded wiring harness
    • Damage
    • If a condition is found, replace the post catalyst HO2S.
  7. If all physical conditions test normal, test or replace the catalytic converter.
scientia non olet · About LEMON Manuals