LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1997 (Engine Controls And Fuel - 2.4L - DTC P0324 To DTC P1400) >> DTC P0341 or P0366 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the CMP sensor for correct installation. Remove the CMP sensor from the engine and inspect the sensor and the O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, repair or replace the CMP sensor.
  2. Connect the CMP sensor connector to the CMP sensor. Turn ON the ignition, with the engine OFF.
  3. Ignition ON, and engine OFF. Observe the CMP Active Counter parameter on the scan tool. Pass a steel object by the tip of the sensor repeatedly. The CMP Active Counter parameter should increment.
    • If the parameter does not increment, replace the CMP sensor.
scientia non olet · About LEMON Manuals