Repair Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Install any components that have been removed or replaced during diagnosis.
Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
Clear the DTCs.
Turn OFF the ignition for 60 seconds.
Ignition ON, command the powertrain relay ON and OFF with a scan tool while observing the powertrain relay circuit status parameters. The circuit status parameters should change from OK to Not Run or Not Run to OK.
- If another DTC is present, refer to Diagnostic System Check - Vehicle and perform the appropriate diagnostic procedure.