LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1996 (Engine Controls And Fuel - 3.5L - DTC P025A/P0300 To DTC P0700) >> DTC P0506 or P0507 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The engine must first be running for greater than 60 seconds, then idle at a steady state for an additional 10 seconds before comparing the actual and desired engine idle speed parameters.
  1. Using a scan tool compare the desired engine idle speed to the actual engine idle speed.
    • Actual engine idle speed should be no greater than 100 RPM below desired.
    • Actual engine idle speed should be no greater than 200 RPM above desired.
  2. Verify that there are no other DTCs set.
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.