LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1996 (Engine Controls And Fuel - 3.5L - DTC P025A/P0300 To DTC P0700) >> DTC P0451, P0452, P0453, or P0454 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the FTP sensor.
  2. Ignition OFF, ensure that the ECM completely powers down and test for less than 5 ohms between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the control module.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal C and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the control module.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the control module.
  4. Verify the scan tool FTP sensor parameter is less than 0.2 volt.
    • If greater than the specified range, test the signal circuit terminal B for a short to voltage. If the circuit tests normal, replace the control module.
  5. Install a 3A fused jumper wire at the signal circuit terminal B and the 5-volt reference circuit terminal C. Verify the scan tool FTP sensor voltage parameter is greater than 4.7 volts.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the control module.
  6. If all circuits test normal, replace the FTP sensor.
scientia non olet · About LEMON Manuals