LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1996 (Engine Controls And Fuel - 3.5L - DTC P025A/P0300 To DTC P0700) >> DTC P0341 >> Component Test

Component Test

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the CMP sensor for looseness and correct installation. Remove the CMP sensor from the engine and inspect the sensor and the O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged; repair or replace the CMP sensor.
  2. Connect the CMP Sensor connector to the CMP Sensor; turn ON the ignition, with the engine OFF.
  3. Ignition ON and engine OFF. Observe the CMP Active Counter parameter on the scan tool; pass a steel object by the tip of the sensor repeatedly. The CMP Active Counter parameter should increment.
    • If the parameter does not increment, replace the CMP sensor.
scientia non olet · About LEMON Manuals